— 3—
Aquatic Bath • 8101 E. Kaiser Blvd., Anaheim, CA • (800) 945-2726 • www.aquaticbath.com
Check dimensions. NOTE: If you’re adding additional accessories such as a grab
bar–additional framing or backing may be needed for support.
Pre-install unit to ensure framing pocket is plumb, square, and a level installation can
be achieved. (See steps 2 and 3.) Adjust framing as needed – shim where necessary.
Remove base.
Measure the distance between the top of the back horizontal flange and the
bottom of the pan ledge, approximately 1-1/2” (40mm). Mark this dimension
on the back studs (or wall), below the first mark.
Installation Data
S
ingle Seat Shower Pan
Fax on Demand # 9033
Level and mark all sides. Front apron should be firmly on the floor.
NOTE: If unit is not level, the joints and seams will not align properly.
Lift and place the base into framing.
Models A B C D
6030SPAN
6
0-1/8"
(1527mm)
3
1-1/4"
(794mm)
8
-1/2"
(216mm)
1
4-1/4"
(362mm)
Pre-Installation Instructions
Kommentare zu diesen Handbüchern